SHAD D0RI3900 Top Case Accessory for Backrest, Black

Fantastically priced, comfortable & possibly the easiest to fit product I have ever known! Well done for actually thinking about how this would be fitted retrospectively! Great job!

Fits it perfectly / side note you will have to drill your top box , if you look inside your top box lid you will see two pre marked locations

The SH47 box lid has 2 dimples indicating where to drill 6mm holes at 200mm centres. The backrest has fixings that measure just 190mm between centres!! The screws are M5. Don't drill the lid until you've measured the centres you need for the backrest. I drilled 2 x 5mm holes at 190mm centres and the backrest screwed straight on. If I'd drilled the dimples I would have been 5mm too wide on each side!There's also a bit of a gap between the top of the backrest and the box lid when fixed, so it isn't as snug as I expected.That said, and after being careful with the drill, my pillion is very happy with the added comfort provided.

Good product

This back rest fits onto the Shad motorcycle back boxes (in my case the SH39).It’s easy enough to fit but does require you to drill two small holes from the inside of the back box. There are markings to ensure you get the holes in the right place.Unfortunately the back rest sits proud of the back box and therefore flexes. I’m not sure if it will snap off at some point as there are only two screws securing the entire back rest and you can slide your fingers between the back box and back rest in places. It would have been much better if the back rest fit snugly into place avoiding any flexing or movement.Time will tell if it lasts.

Doesn't fit. No instructions