Rubber Edge Trim, Self-Adhesive Rubber Edge Trim, Edge Protector for Sheet Metal, EPDM Material, Fit 1/16"(1.6mm), Length 10Ft, Black Color, U Channel Edge Trim

I needed the rubber trim to go between some steel and a gas tank to keep it from rubbing. It worked great and was easy to slid onto the edge of the steel. I like that you could remove the red plastic inside so it would stick and stay in place. Very good product for the money. It also contoured around a corner of the steel.

Works very well , the glue tape is very sticky and adhesive.The instructions for removing the tape works perfectly.I put this on a tray for the bottom of my bird cage because the edges are not folded or rolled so it felt like it was cutting into my fingers when trying to clean the tray .This edge strip is perfect for very thin single sheet edging but they have different sizes and thickness of what you need.Will definitely use again and different sizes

Why did you pick this product vs others?:Purchased this product due to new paint peeling on top edges of bathroom vanity doors. Adheres very strong to the doors. Good for temporary aesthetics until future plans for demolition of vanity.

Worked perfectly to wrap two 3/4" pine swinging doors that were getting beaten up by traffic. They were easy to apply, easy to cut to make the corners and have stayed on through a lot of traffic so far.

I put this on the bottom lip of a heavy steel table to protect floors. No complaints about consistency, fit, adherence, etc. but the red tape protecting the adhesive does seem to shrink with temperature changes resulting in it pulling off in places. This was a minor annoyance that didn't impact application beyond sometimes having the tape on the wrong side which required peeling off the trim and resetting. Think this happened 3 times on 8 linear feet.

Worked very well. Looked good and provided protection for the edge of a ramp I made for our dog. A bit of a challenge to install. Need to measure carefully. Once it’s on you can’t easily reposition it.

Perfect edge trim for 3/4 inch plywood shelves I made for my wife’s home office closetLook way better than a painted edgeEasy to cut and very flexibleThe self adhesive tape makes it a snap to install

used it to cover sheet metal flashing. I put flashing around the septic tank risers as the weedeater was not so friendly. the flashing seemed sharp so by putting this over the edges loos great and should be alot safer. a+