52.4Ft Universal Self Adhesive Weather Seal Strip for Auto, 51/100 x 1/5 Inch Thick, Car Door & Window Weatherstrip with Engine Cover (2 Rolls, 26.2 Ft Each)

I am a little bit sensitive about wind noise and found this product. It was very easy to install and no issue with closing the doors. Also, it stays the place even the tape is not 3M logo tape. (I concerned about the adhesive, but no issues so far). I would say this product eliminates all wind noise, but my next concern was rising noise from the tire. Previously, I didn't notice noise from the bottom part (since wind noise came just next to my ears), but now I can notice it since this product eliminates one of my concerns. Every penny works perfect.

Can't believe how well this product works.Installed on a 2019 Corolla H/B that was a bit drafty and enough road noise to be irritating.Installed product around all four doors,the hatch and engine compartment.Now the vehicle is as tightair and sound wise as Lexus' i have owned.I purchased the longer product and had a couple feet left.Installation:Definitely recommend reunning the product around area to be covered without removing the adhesive-I didn't.Then too clean the surface with rubbing alcohol-I learned that the hard way with previous products.I would absolutely purchase again.Good luck.

Shipped on time and in neat packaging. The width was perfect for my application and the adhesive on the back seemed legit and quality. It stuck very quickly to the metal that I was adhering it to. Time will tell though if the seal strips stay in place and last through the harsh seasons. For now, they look great and do the job I wanted them to do. My only negative is the manufacturer only gives you 1 adhesive pad per roll of seal strip...so each package comes with only 2 adhesive pads which is not enough. When you open the adhesive prep pad, you have to apply it quickly because the chemical on the pad evaporates fast. Once applied though, it works great, but you have one quick pass to do and then apply the seal strip material down. There are times you have to either work slow on laying down the seal strips or cutting them to use for another area and you either run out of adhesive prep pads due to evaporation or simply not enough pads to use for another application somewhere else. Easy solution for the manufacturer, just give us 5 or more application prep pads per pack of seal strips. The prep pads are the size of an alcohol pad, so not sure I see why more can't be included. Other than that, good product, for now.

This EPDM B-shape weather strip is excellent! I am so glad that I took the time to carefully research the width, height, and compressibility of this B-shape EPDM rubber weather strip. It is the perfect width for our RV screen door jam and it easily compresses from it's normal height of 5mm to 2mm filling air gaps nicely.If you follow these few guidelines, it is very easy to firmly apply in a nice straight line:1) Insure the surface you're applying the weather strip to is perfectly clean; wipe it with alcohol just before application.2) After getting an inch or so firmly applied, pull about 6 inches of the red adhesive backing strip loose to expose the adhesive strip and create a slight bend (see pics) and apply the weather strip in a rolling manner... keeping a bend. and pressing it down in spots to secure it as you go.3) * IMPORTANT * Don't pull or stretch the weather strip as you apply it. Doing so will compromise the adhesion because the EPDM rubber strip will then always be under stress - working to shrink to its original length and form with warming and cooling cycles - and eventually the adhesion will fail.4) Only pull about 6 inches of the red adhesive protective strip off of the adhesive at a time; don't let it become too long as you apply the EPDM weather strip. It's easier to work with that way. Stay neat, snip off the red strip after it gets about 2 feet long.5) After you've applied the weather strip, use three finger tips or your thumb to press and release the entire length of the rubber strip to insure the adhesive is securely bonded to the surface it's applied to.Good luck. Enjoy.

The media could not be loaded. I wrote one review already for this one with 5 stars but maybe they don't want 5 stars? instead 4 stars this time -.-I'll try to keep it short. Does it work? Yes, but you need to find the source of the problem (wind noise). Does it stick? Yes, but make sure to clean the surface that you're planning on placing the weather strips. Otherwise, it'll peel off within hours/days/weeks. My still holds pretty well. My problem was, I bought a 2024 Toyota Tundra and I noticed that the wind noise was super loud when you go above 45 mph. The faster you go, the louder it sound. I ended up buying this and was following a reference video that I saw. It did not work initially. If you watch the video, I explain it clearly. I did not bother to take more photos. Sorry. Hope this helps.EDIT: After weeks or driving it and testing it, I've found that it DID NOT help as much as I thought it did. When the wind was blowing directly to the door of my Tundra, it still is making that loud noise that was initially there. It helped somewhat during the 40-50 mph drive and less wind. Going to leave it at 3 stars now.

Rain kept coming in car door, this door stripping did the job

I’m not going to lie I was extremely skeptical when I bought this roll as I didn’t think it would stick at all. However it sticks just fine. Like way better than I expected. I put these on my front two doors and wow no wind noise and my car is better insulated which is super nice. I’m planning on ordering another two rolls for the rear doors. I would say order two or three rolls if you’re planning on doing all four doors plus trunk and hood jams. I would recommend this product especially to the people with some what older cars as the older rubber starts to deteriorate.