InstallGear1/0 Gauge AWG 1ft Power Wire with 150A ANL Fuse Holder - 99.9% Oxygen-Free Copper | 1/0 Gauge Wire | for Auto, Marine, Professionals, RV, Industrial

Poor workmanship lack of integrity,the wire was good quality, the fittings were the best I have seen.the enclosure sucked in had no real support for the fuse the fuse itself was the cheapest you could get.it took up twice the space of a normal fuse holder, when putting it in place the connection they made popped out. After close and timely inspection, I seen the set pin hold the wire was only holding a 1/8 to a quarter of an inch on the cable. On my, connect the wire was held near a half inch from the end.In short, I do not have time to go back and start over with proper fuse holders. I made do with two of them after spending my time to fix what should not have happen to their lack of attention and hopefully can get my money back on the other three. I just hope they hold until I get back.

The side that came pre-attached with the cable was missing parts and the adapter that same cable goes into is undersized for the wire that it ships with.. third time taking one apart (that was brand new mind you) and the oring on it failed.Not a bad fuse box for an engine compartment but no attention to details.

Not much to say. It’s good 👍 didn’t use the fuse because I have a fused distribution block. But the fuse looks great, and the spare 150A fuses is great too